CHS_LHS

30366461EN-08 4 LU-VE Group reserves the right to change specifications without prior notification. exchanger was subjected to a strength test exceeding the design pressure PS. However, during normal use the design pressure PS may not be exceeded. • Heat exchangers supplied by LU-VE Group are normally not equipped with a high-pressure cut out. The installer is responsible for fitting a high-pressure cut out on the system in which the heat exchanger is used. • The heat exchanger shall not be blocked in. If the ambient temperature rises, the pressure could rise and exceed the design pressure. Contact your local LU-VE Group representative if any of the following occurs: hot or damaged power cable; unusual noise during operation; frequent operation of protective devices; unusual smell (such as a burning smell). 1.3 Intended use Air coolers are partly completed machinery according to Machine Directive 2006/42/EC (EU market) - The Supply of Machinery (Safety) Regulations 2008 (UK market) and are intended for incorporation in cooling systems. Declarations of Incorporation are shipped with the units. The product is built according to the following standards and directives: EU market UK market 2014/68/EU Pressure Equipment Directive (PED) Pressure Equipment (Safety) Regulations 2016 (PER) EN 60204-1 Safety of Machinery - Electrical equipment of machines The Electrical Equipment (Safety) Regulations 2016 2014/30/EU Electromagnetic Compatibility Directive Electromagnetic Compatibility Regulations 2016 2014/35/EU Low Voltage Directive The Electrical Equipment (Safety) Regulations 2016 Any applicable local or national legislation US market UL 60335-1 - UL Standard for Safety of Household and Similar Electrical Appliances, Part 1: General Requirements - Sixth Edition UL 60335-2-89 - UL Standard for Safety Household and Similar Electrical Appliances – Safety – Part 2-89: Particular Requirements for Commercial Refrigerating Appliances and Ice-Makers with an Incorporated or Remote Refrigerant Unit or Motor-Compressor - Second Edition ASME B31.5 - Refrigeration Piping and Heat Transfer Components However it is forbidden to operate our equipment before the machine incorporating the products or making part thereof has been declared to be in conformity with the Machine Directive 2006/42/ EC (EU market) or The Supply of Machinery (Safety) Regulations 2008 (UK market). The heat exchanger shall be installed in conformance with the recognized national standards of electrical and refrigeration installation practice. It is not permitted to use the heat exchanger for any purpose other than the one it was designed for by LU-VE Group. 1.4 Where to find product information Detailed technical data for individual product models are available in order related documents, on the product label and in product data sheets. Comprehensive technical information for all LU-VE Group air heat exchanger products is available on-line on luvegroup.com . This includes: • Product manuals • Instruction manuals • Product leaflets & brochures • Product data sheets (selection software) • Dimensional drawings • Electrical wiring diagrams • Certificates LU-VE Group offers world-wide service and support. In case of any questions or uncertainty please contact your local LU-VE Group representative. Contact addresses are available at luvegroup.com . luvegroup.com